MIMAKI TS500P-3200 - Setting the Confirm. Feed; Setting the Amount of Blank Space between Printed Lines; Setting the Feed Mode of the Space of no Data to be Printed

3-21
3
2
2
Setting the Confirm. Feed
Set whether media feeding is performed for checking the
result of the test printing etc. or not.
1
Press the
(MENU)
in Local.
2
Press to select “Machine Setup”
and press the key.
3
Press the
(>>)
twice.
4
Press to select “Confirm. Feed”
and press the key.
5
Press to select ON/ OFF, and
press the key.
• When you select OFF, proceed to the Step 7.
6
Press to select whether you
perform backward feed after confirm. feed
or not and press the key.
• Set value : ON/OFF
7
Press the key several times to
end the setting.
Setting the amount of blank space
between printed lines
Sets the amount of blank space between printed lines.
1
Press the
(MENU)
in Local.
2
Press to select “Machine Setup”
and press the key.
3
Press the
(>>)
twice.
4
Press to select “Spase Btwn PP.”
and press the key.
5
Press to set the amount of blank
space and press the key.
• Set value : None / 10 to 500mm
6
Press the key several times to
end the setting.
Setting the feed mode of the space of
no data to be printed
Change the feed mode of the margin included in the
image data (the space of no data to be printed). If print
data with much margin, set to “Continuous”, then the print
time can be shorten.
1
Press the
(MENU)
in Local.
2
Press to select “Machine Setup”
and press the key.
3
Press the
(>>)
twice.
4
Press to select “Space Feed
Mode” and press the key.
5
Press to set the feed mode and
press the key.
• Intermittent : Perform intermittent feed
operation of the path division unit
• Continuous : Feed the no data part at a time
6
Press the key several times to
end the setting.
• Back-feed operation is performed when printing
ends if the amount of blank space is set in the
decreasing direction.
Be careful of the following in such cases.
• If media is set in the roll holder without using the
feeding device on the back of the printer, the
media tension of the next printing will change due
to back-feed, possibly causing the feed rate of the
media of only the leading edge of the printed
image to change. In such cases, manually rewind
the media.
• This function is disabled if back-feed after drying
feed is set to OFF in the machine settings
“DRYING FEED” ( P.3-20).
• If the printed data already has a blank space,
using this function will result in “Blank space of the
data + Amount of blank space set by using this
function” being output as a blank space.