MIMAKI TS500P-3200 - About Maintenance Menu

4-6
Chapter 4 Maintenance
About Maintenance menu
This provides various settings for doing maintenance on the machine.
The following items can be set in Maintenance settings.
>><< >><< >><< >><< >><<
Maintenance
Station
>
> Nozzle Recovery
>
Auto Maint.
>
Sub Tank
>
Maintenance
Station
>
> Nozzle Recovery
>
Auto Maint.
>
Sub Tank
>
Maintenance
Station
>
> Nozzle Recovery
>
Auto Maint.
>
Sub Tank
>
Maintenance
Station
>
> Nozzle Recovery
>
Auto Maint.
>
Sub Tank
>
REMOTEMENU
TEST PRINT /
CLEANING
Local <Setup 1> 12:00
1340mm
25°C34°C50°C30°C32°C
PRINT POST 1L POST 2L POST 1R POST 2R
MENU
Setup
>
> Maintenance
>
Machine Setup
Nozzle Check
>
>
Information
>><<
REMOTEMENU
TEST PRINT /
CLEANING
Local <Setup 1> 12:00
1340mm
25°C34°C50°C30°C32°C
PRINT POST 1L POST 2L POST 1R POST 2R
REMOTEMENU
TEST PRINT /
CLEANING
Local <Setup 1> 12:00
1340mm
25°C34°C50°C30°C32°C
PRINT POST 1L POST 2L POST 1R POST 2R
Maintenance
Carriage Out
>
> Nozzle Wash
>
Disway Wash
>
Custody Wash
>
Sub Tank
>><<
1/2
Maintenance
Replace Wiper
>
>><<
2/2
Maintenance
Station
>
> Nozzle Recovery
>
Auto Maint.
>
Sub Tank
>
Charge Ink
>><<
1/2
Maintenance
Replace Ink Tank
Tank Calibration
>
>
>
>><<
Waste Expored ink
2/2
Maintenance
Station
>
> Nozzle Recovery
>
Auto Maint.
>
Sub Tank
>
Charge Ink
>><<
1/2
Maintenance
Replace Ink Tank
Tank Calibration
>
>
>
>><<
Waste Expored ink
2/2
Maintenance
Station
>
> Nozzle Recovery
>
Auto Maint.
>
Sub Tank
>
Charge Ink
>><<
1/2
Maintenance
Replace Ink Tank
Tank Calibration
>
>
>
>><<
Waste Expored ink
2/2
Maintenance
Station
>
> Nozzle Recovery
>
Auto Maint.
>
Sub Tank
>
Charge Ink
>><<
1/2
Maintenance
Station
>
> Nozzle Recovery
>
Auto Maint.
>
Sub Tank
>
Charge Ink
>><<
1/2
Maintenance
Station
>
> Nozzle Recovery
>
Auto Maint.
>
Sub Tank
>
Charge Ink
>><<
1/2
 Press the key to perform “Station maintenance”.
The Station menu can be displayed easily without selecting [MENU]-[Maintenance] from Local.
Press the [SEL] key to display “MAINT” for [FUNC2] , and then press the [FUNC2] key.
: Press this to select Maintenance menu, or to switch to the
previous screen.
: Press this to use the maintenance function.
: Press this to switch to the next screen.
: Use these to select a setting item.
: Press this to confirm a setting, etc..
 Maintenance menus at-a-glance