4-11
4
2
Chapter 4 Maintenance
When the Machine Is Not Used for a
Long Time (Custody Wash)
When the machine is not going to be used for a week or
more, use the cleaning function for custody to clean the
head nozzles and ink discharge passage.After this, keep
the machine in custody.
1
Press the key,and then press the
(MAINT)
in LOCAL.
• The Maintenance menu appears.
2
Press to select “Custody Wash”,
and press the key.
• The carriage moves onto the platen.
3
Open the lower part of the right side front
cover.
(1) Remove the screws of the lower part of the
right side front cover (for two positions).
(2) Hold the upper of the lower part of the right
side front cover and pull it to the front.
• Open the lower part of the right side front cover
with the supplied screwdriver.
4
Clean the wiper and the bracket, and press
the key.
(1) Open the right maintenance cover then pull
out it by holding projections at both ends of
the wiper.
(2) Clean the wiper and bracket with a clean
stick dipped in maintenance washing liquid
for maintenance. (ML003-Z-K1: Cleaning
Liquid 03 MAINTENANCE KIT)
• Wipe off so that maintenance washing liquid
for maintenance will not remain.
(3) Insert it in the original position by holding the
projections at both ends of the wiper.
5
Clean the cap rubber and cap rubber cover.
• Wipe off the ink sticking to the cap rubber and cap
rubber cover with a clean stick dipped in cleaning
solution for maintenance. Wipe off so that
cleaning solution for maintenance will not remain.
• At this time, the discharge passage is cleaned
automatically.
6
Press the key.
Check the items on the right beforehand.
Is “NEAR END” or “INK END” displayed?
• The cleaning solution or ink is absorbed when the nozzles
are washed.
At this time, if the state of "no ink" or "almost no ink" is
detected, the nozzle washing operation cannot start.
• Refill ink.
• Be sure to use the dedicated cleaning Liquid 03
MAINTENANCE KIT (ML003-Z-K1).
• Until wiper/ bracket cleaning is competed, “Please
clean the wiper.” is displayed on the screen. After
the work up to the step 5 is completed, press the
[ENTER] key.
Screw
Lower part of the right
side front cover
• Until washing liquid is filled, “Fill the liquid.” is
displayed on the screen. After the work up to the
Step 8 is completed and you close the front cover,
press the [ENTER] key.
Cap rubber Cap rubber cover
To Next Page
Loading...
