2-21
2
2
2
2
Cutting a media
When you cut the media after printing of roll media has
been completed, cut it with the key on the operation
panel.
1
Press the key,and then press the
(MEDIA)
in LOCAL.
• Media setting menu will be displayed.
2
Press to select “Media Cut” and
press the key.
3
Press to select “Cut Position”
and press the key.
4
Press to adjust the cutting
position and press the key.
• The media is cut.
• If there is no need to adjust the cut position,
please press the [ENTER] key without pressing
the [] []. It will cut the media on the position.
• When the cutting has been completed, the current
mode returns to LOCAL.
• When a media is cut, be careful that the printed
side does not touch the floor or the printed side of
other already cut media.
• When using the take-up device, take up a cut
medium using the switch of the take-up device.
• Before performing cut, fix the tension bars on the
front and the rear surfaces of the machine at the
locking position.
• During the origin setting with the jog keys, you can
also perform media cutting by pressing the
[FUNC2] (CUT).
To Next Page
Loading...
