MIMAKI TS500P-3200 - Setting the Cleaning Level; Charging Ink

4-18
Chapter 4 Maintenance
Setting the Cleaning level
The head cleaning level is set.
1
Press the
(MENU)
in Local.
2
Press to select “Maintenance”,
and press the key.
• Maintenance menu appears.
3
Press to select “Auto Maint.”,
and press the key.
4
Press to select “Cleaning”, and
press the key.
5
Press to select the cleaning level,
and press the key.
• Set value : OFF/Lv.1/Lv.2/Lv.3
• When you select OFF, proceed to the Step 7.
6
Press to select the cleaning type,
and press the key.
• Set value : Soft/ Normal/ Hard
7
Press the key several times to
end the setting.
Charging ink
If auto charging is not possible, or if you want to check the
content of the IC chip before charging ink, perform the
following operation.
1
Press the
(MENU)
in LOCAL.
2
Press to select “Maintenance”,
and press the key.
3
Press to select “Charge Ink”, and
press the key.
4
Press to select the ink tank to be
charged.
5
Press the key.
• If the selected ink tank is near its expiration date, a
confirmation screen will appear. If OK, press [].
• The selected tank cannot be charged an either of
the following situations. (P.3-28)
(1) The volume of remaining ink managed by
the printer is 100%.
(2) The ink expiration date has passed by 2
months or more.
Exp i r a t i on : 1MONTH
CHARGE ANYWAY ?
Exp i r a t i on : 1MONTH
NO < > YES
Displayed
alternately
Exp i r a t i on
CHARGE ANYWAY ?
Exp i r a t i on
NO < > YES
Displayed
alternately