2-14
16
Press to loosen the media.
• Loosen the media until it reaches to the floor.
17
With switches of the take-up device, roll up
the media about once.
(1) Making the left switch to [MANUAL] and the
right switch to the direction taking up the
media, take up the media.
(2) Just before the media stretched tight, turn
the left switch to [AUTO] to stop.
18
Press again to loose the media.
• Loosen the media until it reaches to the floor.
19
At the front, lift the tension- bar down
slowly.
• Unlock the tension-bar, and then lift it down.
20
Press to lift the tension-bar up
and to stretch the loosened media.
• Turn the switch to [AUTO]. Tension-bar lifts, taking
up the media, and automatically stops at the
proper position.
Setting leaf media
Unlike roll media, leaf media does not need to be retained
with the roll holders.
1
Open the front cover.
2
Raise the clamp lever.
3
Insert the leaf media between the platen
and the pinch rollers.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
• Set the media so that the media end does not
reach the slot of the post-heater.
4
Hold the media with the media press
gently.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
• When using a thick media, remove the media
press from the media before printing.
• Surface waviness or ruck may affect the quality of
currently printed image.
When fixing media with tape, align the media
along the direction indicated with an arrow in the
figure.
• If you pull the media too much when fixing with
tape, the media tension may not be even. And, it
may negatively affect the media feeding.
• Rolling up the media too tight, covers of take-up
device opens and an error [Cover Open] appears.
In this case, open the right cover of the take-up
device, and loosen the tension of the media.
• When the tension bar does not move upward even
if you press the [][] switch, stretch the slack
media by operating the switch.
(1) Set the
switch to the take-up direction of
the media, and turn the switch to [MANUAL].
(The tension-bar is lifted.)
• When the media is fed and the ten-
sion-bar is not lifted, turn the
↑↓
switch to the other side.
(2) When the tension bar arm becomes parallel
with the floor, turn the switch to [AUTO] to
stop the tension bar.
(3) Turn the
switch to the take-up direction
of the media.
• The media between the take-up device and
carriage cannot be printed.
Tension bar
Tension-bar lock plate
• If the media gets near to the right side too much,
the warning message “MEDIA SET POSITION R”
displayed after media detection. Set the media
again.
To Next Page
Loading...
