2-13
2
2
2
2
(2) Insert the media between the platen and the
pinch roller.
• Pull the media out of the roll so that the media
can be grasped from the front of the machine.
(3) Push down the clamp lever from the back of
this machine.
• The media is held.
9
Locking the roll stopper.
(1) Pull the roll stopper in the directionshown
right.
(2) Press the lock pin to hold the roll stopper.
10
Pull out the roll media out.
(1) Open the front cover.
(2) Raise the clamp lever from the front of this
machine.
(3) Pull out the roll media gently and then stop
pulling when locked lightly.
11
Push down the clamp lever from the front
of this machine.
12
Hold the media with the media press
gently.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
• When using a thick media, remove the media
press from the media before printing.
13
Close the front cover.
• The media selection screen is displayed.
14
Press the to select "ROLL" .
• Detects the media width.
• When “Setting the Display of Media Remain” of
the machine setup is "ON" ( P.3-19), the
screen for entering media remaining amount is
displayed after detecting the media width.
(P.2-11)
15
Secure the media on the take-up device.
(1) Feed the media up to the core of the roll
media of the take-up device by pressing [].
(2) As indicated, fix the media on the paper core
with tape so that the printed surface may be
“involuted”.
• Along the paper core, fix the media on
several positions with tape in the order in the
figure so that the media may not wrinkle.
• Check the position of the media edge surface and
the feed roller.
• When you clamp the media edge surface with the
pinch roller and the feed roller, the quality of
transferring media may be degraded. Before
setting media, adjust the position of the roll holder
fixing the media.
To Next Page
Loading...
