4-22
Chapter 4 Maintenance
For the operation limitation by the
amount of waste ink
According to the amount of waste ink that has
accumulated in the waste ink tank, there are items that
will not be able to operate in this machine.
Discarding waste ink diligently is recomended.
Replacing consum-
ables
Replacing the wiper
The wiper is consumable.When the warning message
"Replace a WIPER" is displayed, it is necessary to
replace the wiper, immediately replace the wiper with a
new one.
Also, wipe ink sticking to the lower surface of the wiper
cleaner off.
1
Press the key,and then press the
(MAINT)
in LOCAL.
• The Maintenance menu appears.
2
Press to select “Replace Wiper”,
and press the key.
3
Press the key.
• The carriage moves onto the platen.
• The number of times when the wiper was used is
reset.
4
Open the rght maintenance cover then
remove the wiper.
• Pull out the wiper by holding the protrusions at its
both ends.
5
Insert a new wiper.
• Insert a new wiper by holding its both ends.
• There is no direction to the wipers. They can be
inserted with either side facing forward.
Message
Waste ink near full
Waste ink full
Waste ink tank none
Operation restriction
No
Following operations will
not be activated.
• Operation using ink
•Print
• Remote transition
• If occurs during print-
ing, transit to local
after printing comple-
tion
Solution
It can be used as they are,
but waste ink tank would be
immediately full.
Dispose the waste ink as
soon as possible.
Dispose of waste ink
according to regional laws
and regulations.
Emptying the waReplace
the waste ink tank with new
oneste ink tank referring to
"Replace the waste ink tank
with new one"
Then, please reset the
waste ink tank.
Dispose of waste ink
according to regional laws
and regulations.
• A cleaning wiper (SPA-0193) is an option.Buy one
through the dealer in your region or at our service
office.
• Until the replacement work is completed,
[COMPLETED” is displayed on the screen. After
the work up to the Step 3 is completed and you
close the lower part of the right side front cover,
press the [ENTER] key.
To Next Page
Loading...
