MIMAKI TS500P-3200 - Maintenance Menus At-A-Glance

4-7
4
2
Chapter 4 Maintenance
Maintenance menus at-a-glance
Item Set value Meaning
Station
For carrying out maintenance on the carriage and station periphery.
Carriage Out
(P.4-8)
Moves the carriage out, for carrying out cleaning of the cap periphery,
head, wipers, etc.
Nozzle Wash
(P.4-14)
1 to 15min
Soaks the nozzle surfaces in maintenance cleaning fluid, for carrying
out recovery from nozzle missing or bent.
Pump Tube Wash
(P.4-10)
Executes washing of the suction pump tubes.
Custody Wash
(P.4-11)
1 to 15min
Carried out when the machine is going to be out of use for an extended
period. Washes the nozzles and tubes beforehand, to keep the
machine in fine condition.
Replace Wiper
(P.4-22)
Used when replacing the wiper. If the wiper is replaced, the number of
times the wiper was used that is managed in this device is reset.
Nozzle Recovery
(P.4-15)
For printing using another nozzle, if nozzle wash and so forth fail to effect recovery from nozzle missing, etc.
Print Used to print a pattern and to check and/or register clogged nozzles.
Entry Registers the faulty nozzle identified by “Print”.
Check Checks recoverable printable conditions.
Reset Resets a registered faulty nozzle.
Auto Maint.
(P.4-17)
For having the various maintenance functions executed automatically. Set the execution interval for each
maintenance function.
Refresh
OFF/Lv.1/Lv.2
/
Lv.3
For setting the activation interval for refresh.
Cleaning
OFF/Lv.1/Lv.2
/
Lv.3
For setting the activation interval for head cleaning.
When set to other than "OFF", you can set the cleaning type (Soft /
Normal / Hard).
Sub Tank ( P.5-4)
Used to charge ink and to solve the problems including ink errors and
nozzle missing .
Charge Ink ( P.4-18)
Used when ink cannot be automatically charged, or if you want to
charge ink after confirming the contents of the IC ship.
Replace Ink Tank ( P.4-24)
Used to replace a expired ink tank and to reset the ink charge
information.
Waste Expored Ink ( P.4-24) Discard the expired ink and reset charged information.
Tank Calibration ( P.4-28) Make the correction of the weight balance of the ink supply unit.