2-12
Setting a narrow roll media
When you use narrow roll media (up to 1m), set the media
on the narrow roll holder.
1
Fix the tension bar of the rear surface side
on the tension-bar lock plate.
• The tension-bar lock plate is on the left side of the
machine rear surface. Raise the tension bar and
fix it with the tension-bar lock plate.
2
Set both of “Setting Feeding unit” and
“Setting Take-up unit” of the machine
setting to “OFF”.( P.3-18,P.3-19)
3
Move the roll holder on the back of this
machine.
• Loosen the roll holder fixing screw and then move
it.
• Move the roll holder to the position where the
media may be right seen from the front of the
machine.
4
Tighten the roll holder fixing screw.
• Check the Steps 2 to 3 again.
5
Set the left end of the core of the roll media
on the left roll holder.
• Push the roll media onto the roll holder until the
roll core is all the way seated.
6
Loosen the screw of the right roll holder,
and insert the holder into the paper core.
7
Raise the clamp lever in the rear side of
this machine.
8
Insert the roll media in this machine.
• The roll media can be smoothly inserted by
slanting the media.
(1) Pull the media out of the roll to the head of
the platen.
• When using the media take-up machine, be
careful about the points below:
• At the feeding side, set the printed surface to
“revoluted” (inside out).
• At the take-up side, set the printed surface to
“involuted”. (If you set it to “revoluted”, it may
adversely affect the media feeding.)
• Be sure to handle the tension-bar gripping outside
of the tension-bar lock plate. Gripping other parts,
your hand may get stuck in.
Roll holder
Roll holder fixing screw
• When setting long media, the roll holder hits the
rail supporter in the center of the holder.
In this case, unhook a pin from the supporter while
lifting media support bar, remove the rail
supporter, and slide the roll holder. After that, set
the rail supporter again.
To Next Page
Loading...
