4-19
4
2
Chapter 4 Maintenance
6
Insert the IC chip included with the 2 liter
ink bottle.
• When an IC chip is inserted into the printer and
the information on the IC chip is loaded, the
display will change as shown on the right.
• IInsert the IC chip with the metal part facing rear
side and down. If you insert the wrong side by
accident, it causes faulty or damage of the IC
chip.
• Do not touch the metal part of the IC chip. It may
break the IC chip by static, or may cause read
error by stain or flaw.
7
When the “CHARGE START” confirmation
screen appears, press .
• Charging starts.
• The ink information on the IC chip appears in the
display.
8
When charging is complete, the buzzer will
sound momentarily and then the screen will is
display the messsage “Complete Ink Charge”.
• If the inserted IC chip is near its expiration date, a
confirmation screen will appear. If OK, press [].
• If there is a problem with the inserted IC chip and
you can not charge , the display shows the reason.
• If there are multiple problems, use [][] to scroll
through them.
Down
Metal part facing
rear side
CHARGE I NK : TANK 1 - M
PLEASE I NSERT I NK I C
IC chip inserting port
Exp i r a t i on : 1MONTH
CHARGE ANYWAY ?
Exp i r a t i on : 1MONTH
NO < > YES
Displayed
alternately
Exp i r a t i on
CHARGE ANYWAY ?
Exp i r a t i on
NO < > YES
Displayed
alternately
• While the ink is charging, the screen is displayed
*Ink Charge*.
Do not remove the IC chip or turn the printer off.
• To check the volume and expiration date of the ink
that has been charged, press the [ENTER] key in
Local. (P.3-28)
To Next Page
Loading...
