2-7
2
2
2
2
5
Set the roll shaft with the paper core on the
take-up device, and close the covers on
the right and left sides of the roll shaft.
(1) Fitting the A part of the roll shaft to the B part
bearing of the machine, put it on.
(2) Close the left cover.
(3) Slide the lever to lock.
(4) Close the right cover.
(5) Lifting the AMF bottom cover.
(6) Slide the lever to lock.
Setting a Roll Media
Set a roll media to the feeding device on the back.
When setting a roll media, set “Feeding unit” and “Take-up
unit” of the machine setting to “ON”.
1
Set both of “Setting Feeding unit” and
“Setting Take-up unit” of the machine
setting to “ON”.( P.3-18,P.3-19)
2
Remove the roll shaft on the feeding
device at the back of this machine.
(1) Lower the lever that is attached to the right
and left of the cover of media feeding device
and release the lock.
(2) Open the covers.
(3) Remove the roll shaft.
• To prevent dust, set paper core or media to the
roll shaft on the table or sheet.
Dust on the paper core or the media may cause
defective print.
• Carefully set C part so as not to hit near frame.
Scratches can cause malfunction.
• Put the shaft on gently, not roughly.
• Take care not to drop the media on your foot when
setting the media.
• Handle clamp levers carefully.
Do not push the lever up when tension-bar is lifted.
Be sure to fix the tension-bar with the tension-bar
lock plate and push up / down the lever.
• When using the media take-up machine, be
careful about the points below:
• At the feeding side, set the printed surface to
“revoluted” (inside out).
• At the take-up side, set the printed surface to
“involuted”. (If you set it to “revoluted”, it may
adversely affect the media feeding.)
• When the media is set on the narrow roll holder,
remove the media. In addition, move the narrow
roll holder to the both edges of the machine. It may
cause media feeding defect.
• When carrying the roll shaft, be sure to grip
handles on the both ends. Gripping other parts,
your hand may get stuck in the printer.
To Next Page
Loading...
