2-10
16
Close the front cover.
17
Press to select "ROLL" .
• Detects the media width and thickness.
• If the media thickness could not be detected, the
error message is displayed. Enter the media
thickness by referring to P.2-11 “When media
thickness could not be detected”.
• When you set “Media remaining amount display”
and “Media detection” to “ON” and “MANUAL”
( P.3-19,P.3-20) in the machine setting, input
screen for the media thickness and the remaining
amount is displayed after detecting the media
width. ( P.2-11)
18
Secure the media on the take-up device.
(1) Feed the media up to the core of the roll
media of the take-up device by pressing [].
(2) As indicated, fix the media on the paper core
with tape so that the printed surface may be
“involuted”.
• Along the paper core, fix the media on
several positions with tape in the order in the
figure so that the media may not wrinkle.
19
Press to loosen the media.
• Loosen the media until it reaches to the floor.
20
With switches of the take-up device, roll up
the media about once.
(1) Making the left switch to [MANUAL] and the
right switch to the direction taking up the
media, take up the media.
(2) Just before the media stretched tight, turn
the left switch to [AUTO] to stop.
21
Press again to loose the media.
• Loosen the media until it reaches to the floor.
22
At the front, lift the tension- bar down
slowly.
• Unlock the tension-bar, and then lift it down.
23
Press to lift the tension-bar up
and to stretch the loosened media.
• Turn the switch to [AUTO]. Tension-bar lifts, taking
up the media, and automatically stops at the
proper position.
• If the media gets near to the right side too much,
the warning message “MEDIA SET POSITION R”
is displayed after media detection. Set the media
again.
• Surface waviness or ruck may affect the quality of
currently printed image.
When fixing media with tape, align the media
along the direction indicated with an arrow in the
figure.
• If you pull the media too much when fixing with
tape, the media tension may not be even. And, it
may negatively affect the media feeding.
• Rolling up the media too tight, covers of take-up
device opens and an error [Cover Open] appears.
In this case, open the right cover of the take-up
device, and loosen the tension of the media.
• When the tension bar does not move upward even
if you press the [][] switch, stretch the slack
media by operating the switch.
(1) Set the switch to the take-up direction of
the media, and turn the switch to [MANUAL].
(The tension-bar is lifted.)
• When the media is fed and the ten-
sion-bar is not lifted, turn the
switch to the other side.
(2) When the tension bar arm becomes parallel
with the floor, turn the switch to [AUTO] to
stop the tension bar.
(3) Turn the switch to the take-up direction of
the media.
• The media between the take-up device and
carriage cannot be printed.
Tension bar
Tension-bar lock plate
To Next Page
Loading...
