Chapter 3 Setup
3-4
Auto Nozzle
Maint.
(P.3-22)
Auto Cleaning
(P.3-12)
ON
/ OFF
Sets the automatic cleaning operation for the
head performed before or during printing.
Cleaning
Interval
Length 0.1 to 20.0
to 100.0 m
Performs cleaning at intervals of the set
length.
File 1 to 10
to 1000
Performs cleaning whenever the set number
of files has been processed.
Time 10
to 120 min Performs cleaning at intervals of the set time.
Type Soft
, Normal, Hard Sets the type of cleaning to be performed.
Cln.BeforePrint 10 to 720 min/ OFF
Performs cleaning before printing start if the
specified time has passed since the previous
printing completion time.
Nozzle Check ON
/ OFF
Set it to ON to perform nozzle check
automatically.
Check
Interval
Length 0.1 to 3
0.0 to 100.0 m
Performs nozzle check at intervals of the set
length.
File 1 to 3
0 to 1000
Performs nozzle check whenever the set
number of files has been processed.
Time 10 to 30
to 120 min
Performs nozzle check at intervals of the set
time.
Cleaning Type Soft
, Normal, Hard, Auto
Sets the type of cleaning to be performed
when any nozzle missing error is detected.If
"Auto" is selected, the machine performs an
optimum cleaning according to the nozzle
recovery state.
RETRY COUNT 0
to 3
Performs recovery operations for missing
nozzles by the set number of times.
Auto Nozzle
Recovery
ON
/ OFF
Set it to ON to perform nozzle recovery
automatically.
Judgement
Condition
1 to 10
to 100 / OFF
Sets the number of detected missing nozzles
in each head line and color that leads to
determination of a "nozzle missing" error.
When set to OFF, the machine performs no
nozzle check.
Interval Wiping ( P.3-15) 3 to 255 min, OFF
Sets the wiping operation performed after
printing is completed.
Head Gap ( P.3-28) 1.5 to 2
to 7.0mm Sets the head gap.
Setup Reset ( P.3-28) The configulation in the settings 1-4 can be reset ondividually.
*1. The underlined has been set as default.
*2. This is the setting value to be used for printing when setting value is not specified at the RIP software (Host) side, or, you give priority to the setting value at the
machine side.
Function name Set value
*1
When no instruc-
tion from RIP
exists
*2
Outline
To Next Page
Loading...
