4-16
Chapter 4 Maintenance
8
Register the Nozzle number that needs
Nozzle Recovery and then press
key.
(1) Select the registration number from 1 to 10
by pressing [][] key and press the
[ENTER] key.
(2) Register the nozzle number that needs
recovery by pressing [][] key and press
the [ENTER] key.
9
Press the key several times to
end the setting.
Check the print condition for which
nozzle recovery cannot be performed
Depending on the nozzle registered, there is the mode not
reflected by “RECOVERY”.
Check the unrecoverable print conditions with the check
function.
1
Press the
(MENU)
in Local.
2
Press to select “Maintenance”,
and press the key.
• Maintenance menu appears.
3
Press to select “Nozzle
Recovery”, and press the key.
4
Press to select “CHECK”, and
press the key.
• The mode for which nozzle recovery is invalid is
displayed.
• If there is no mode for which nozzle recovery is
invalid, “NONE” is displayed.
5
Press the key several times to
end the setting.
Line-1AB
No.1
No.2
16
128
No.3
184
No.4
OFF
No.5
OFF
>><<
Recovery nozzle No. or OFF
Registration number : 1 to 10
Nozzle missing
No.184
Nozzle number
Nozzle missing No.16
Nozzle missing
No.128
Registration
number
Recovery
Nozzle No.
State
1 16 Target for nozzle recovery
2 128 Target for nozzle recovery
3 184 Target for nozzle recovery
4 OFF No registration
5 OFF No registration
Example of nozzle to be recovered
• Up to 10 nozzles can be registered per 1 nozzle
line.
• Even if you use this function, time required for
drawing does not change.
• The nozzle recovery may not reflected if printing is
performed under the following conditions:
• If there are many registered nozzles, it takes time
to display the check result.
4-colors ink set
Resolution Pass Scan speed
360 x 360HQ 2 pass Normal speed
540 x 360 2 pass High speed
720 x 720 4 pass High speed
720 x 1080 6 pass High speed
6-colors ink set
Resolution Pass Scan speed
540 x 360 4 pass High speed
540 x 540 6 pass High speed
720 x 720 8 pass High speed
720 x 1080 12 pass High speed
To Next Page
Loading...
