Chapter5 Troubleshooting
5-8
Message displayed in Local mode
Invalid Operation
Take-up Connect
The function cannot be executed
because the connection between take-
up and feeding is reversed.
• Restart the unit.
If displaying again, contact your local distrib-
utor, our sales office, or service center.
Invalid Operation
Feeding Connect
The function cannot be executed
because the connection between feed-
ing and take-up is reversed.
Invalid Operation
Take-up Unit None
The function cannot be executed
because the take-up unit is not con-
nected.
Invalid Operation
Feeding Unit None
The function cannot be executed
because the feeding unit is not con-
nected.
Invalid Operation
Take-up EmerSW On
The function cannot be executed
because the emergency stop switch of
the take-up unit is pushed.
• Execute the operation after releasing the
emergency stop switch of the take-up unit.
Invalid Operation
Feeding EmerSW On
The function cannot be executed
because the emergency stop switch of
the feeding unit is pushed.
• Execute the operation after releasing the
emergency stop switch of the feeding unit.
Invalid Operation
Take-up Unit Power
The function cannot be executed
because the normal state of the inverter
of the feeding unit cannot be confirmed.
• Execute the operation after restarting the
unit and confirm that the inverter power sup-
ply of the take-up unit is in the normal state.
Invalid Operation
Feeding Unit Power
The function cannot be executed
because the normal state of the inverter
of the feeding unit cannot be confirmed.
• Execute the operation after restarting the
unit and confirm that the inverter power sup-
ply of the feeding unit is in the normal state.
Invalid Operation
Take-up Relay Welding
The function cannot be executed
because there is a possibility that the
relay of the take-up unit is broken.
• Restart the unit.
If displaying again, contact your local distrib-
utor, our sales office, or service center.
Invalid Operation
Feeding Relay Welding
The function cannot be executed
because there is a possibility that the
relay of the feeding unit is broken.
Invalid Operation
Wiper Move Failure
The function cannot be executed
because the wiper does not operate
properly.
• Clean the surroundings of the wiper and
restart the device, then execute the function.
Display Cause Measures
Lower the clamp lever Clamp lever is raised. • Lower the clamp lever.
Please set the media No media is set. • Set the media.
Temporary Suspension The state where printing is suspended.
• Press the remote key to resume printing or
execute data clear, and stop it.
Check Waste Ink
The count of the waste ink tank exceeds
the specified amount (80%).
• Check the amount of ink in the waste ink
tank.
• Reset the count after correcting error or
replacing the waste ink tank.
Replace Waste Ink Tank
The waste ink tank count exceeded the
specified amount (90%).
• Check the amount of ink in the waste ink
tank.
• Reset the count after correcting error or
replacing the waste ink tank.
!Can'tPrint/Ink IC
It is impossible to print, because the ink
IC chip cannot be used.
• Replace the ink pack or 10kg ink tank and
ink IC chip.
Expiration Near M_ _ _ _ _ _ _
The ink has expired (less than 2 months
from expiration).
• Replace the ink pack or 10kg ink tank and
ink IC chip.
(It can be used from the expiration date up to
2 months.)
Display Cause Measures
To Next Page
Loading...
