MIMAKI UJF-3042FX - Increasing Cumulative UV Irradiation When the Number of Passes Is Low

3-17
Various settings
3
Useful Function
Increasing cumulative UV irradiation when the number of passes is low
When the number of passes is low (720x600: 8 passes or less, 720x900: 12 passes or less, 720x1200: 8 passes
or less), cumulative UV light quantity irradiated to the discharged ink is smaller, which may cause insufficient UV
curing for some media type.
Setting [UV Curing Level] reduces the number of nozzles to be used when the number of passes is low.
Increasing the scan count increases the cumulative UV light quantity. (Supported from the firmware ver.3.80)
1
Press the key in the local mode.
2
Select the [SET UP] by pressing the or key,
and press the key.
3
Select the [UV Curing Level] by pressing the or
key, and press the key.
4
Select curing level to be set by pressing the or
key, and press the key.
• Set value: 0(default), 1, 2, 3
5
Press the key several times to end the setting.
• This operation is available only when the number of passes is low (720x600: 8 passes or less, 720x900:
12 passes or less, 720x1200: 8 passes or less). In other drawing modes, the number of nozzles used
normally are used for drawing.
• Due to a reduced number of nozzles used for drawing, the drawing time becomes longer.
<LOCAL>
FUNCTION
FUNCT I ON
WOR K S E T < E N T >
ENTER
SET UP
UV Cur i ng Leve l <en t >
ENTER
SET UP
UV Cu r i n g L e v e l : 0
ENTER
END