Ink cartridge
4-9
4
Maintenance
Shaking the white ink cartridge
Shake the white ink cartridge when starting the device or when the following screen is displayed.
(Supported from the firmware ver.4.10)
1
Pull out the white ink cartridges from the ink
station.
2
Slowly shake the white ink cartridge more than twenty times right and left.
• To prevent ink from leaking when you shake the cartridge, wear gloves and firmly cover the A part of the
upper surface of the cartridge and the B part of the bottom surface of the cartridge with paper towels.
Then, shake it more than twenty times right and left so that ink flows inside the cartridge.
3
Return the white ink cartridge to the ink station and press the key.
• If you shake it too strong, the pack inside may be damaged and it may cause ink leakage. Therefore,
perform this carefully.
• If the remaining amount of ink is less, ink in the cartridge cannot be beaten enough. Tilt the cartridge
until it becomes vertical.
Part A
(Insertion hole of the needle)
Part B
(Gap on the bottom surface)
Cover with paper towel
firmly and shake ink slowly
Repeat this
A part
To Next Page
Loading...
Need help?
General