MIMAKI UJF-3042FX - Perform Setting to Reduce Stripes between Passes; Perform Setting to Reduce Stripes Be- Tween Passes

3-8
Perform setting to reduce stripes between passes
What is the MAPS Function?
If performing media correction does not resolve feeding stripes, use the MAPS (Mimaki Advanced PassSystem)
function to disperse the pass boundary to make the feeding stripes less visible.
With the UJF-3042, you can use the MAPS2 function
*1
. (Supported from the firmware ver.4.10)
Setting MAPS2 Function
1
Press the key in LOCAL.
2
Press the key.
3
Press to select [MAPS].
4
Press the key.
5
Press to select MAPS2.
•Set Value：MAPS2, OFF
6
Press the key.
• If you selected OFF in step 5, back to step 3.
7
Press to select “AUTO” or “MANUAL”.
• AUTO : Set the print pattern and smoothing level to the
recommended value automatically depending on
printing mode.
• MANUAL : You can adjust the set value.
*1.This helps reduce feeding stripes and uneven color.
• Enabling the MAPS function, slight color change may be found compared to when the MAPS function
disable. Use it after checking effect in advance.
• MAPS may not be effective depending on image to be printed. Use it after checking effect in advance.
• If feeding stripes and color change is not improved by “AUTO” setting, please adjust the
print pattern and smoothing level by “MANUAL” setting.
FUNCT I ON
SETUP <ENT>
FUNCTION
SETUP
FEED COMP . <ENT>
ENTER
SETUP
MAP S < ENT >
MAP S
MAP S : OF F
ENTER
MAP S
MAPS : MAPS2
MAP S 2
MAP S 2 : MANUA L
ENTER
MAP S 2
MAP S 2 : AU TO