4-10
600ml Ink cartridge
To use the 600ml ink cartridges, register the case weight (this page) and the cartridge weight (next page).
Please prepare your scale (which can weigh up to 1200g in 1g).
Registering the case weight
Firstly register the case weight in the following procedures.
For the 600ml cartridges, this machine recalculates remaining amount of ink from a registered case weight.
1
Weigh the case of an empty cartridge on the scale.
• Do not attach the IC chip and the ink pack when weighing.
2
Prepare the 600ml cartridge.
• Load the IC chip and the ink pack into an empty cartridge.
3
Set the 600ml cartridge in the local mode.
4
Enter the weight checked at the Step 1 by pressing
the or key, and press the key.
• If other 600ml cartridges are found, an entry screen is
displayed. Repeat the Step 1 to 4.
• When all weights of the 600ml cartridge cases are entered, this
machine returns to the local mode to enable drawing or
cleaning.
• Press the key to cancel the weight entry, but a
screen shown on the right appears in the local mode, and the
600ml cartridge is invalid until the weight is entered.
• If the weight entry is canceled, remove and reinsert the
cartridge to display the weight entry screen again, and enter the weight.
• If the case is replaced, register the case weight again from [MACHINE SET]. ( P.3-30)
To Next Page
Loading...
Need help?
General