7-5
7.3.2 Upgrading Wireless Network Function
Refer to corresponding section to install the wireless network assembly in your patient
monitor.
Refer to the Operator’s Manual for the use of wireless network.
7.3.3 Upgrading Recorder
Refer to corresponding section to install the recorder in your patient monitor.
Refer to the Operator’s Manual for the use of recorder.
7.3.4 Upgrading Analog Output
Refer to corresponding section to replace the interface board assembly and DVI interface
board.
Refer to the Operator’s Manual for use of the analog output.
7.3.5 Upgrading CF storage card function
Refer to Removing the CF Card Assembly section to install CF card kit. Then insert the CF
card into the slot.
Refer to the Operator’s Manual for the use of CF card.
NOTE
z When upgrading wireless network, analog output and CIS function for a patient
monitor with standard configuration, you have to replace old PCBAs in the patient
monitor with corresponding PCBAs included in the upgrade kit and remove the
covers of related connectors.
To Next Page
Loading...
