Appendices
20-43
Appendix D Optional Functions
The following functions are optional. You cannot use an optional function unless it
is configured.
Name Description Operation
Dynamic Short Trends The main screen displays the
dynamic short trends.
Press the MENU button. In SYSTEM MENU, select
SYSTEM SETUP >> to enter the SYSTEM SETUP
menu, and then select TREND SCREEN in the
FACE SELECT sub-menu.
oxyCRG (Oxygen
Cardio-Respirogram)
The main screen displays the
oxyCRG and the relevant
information.
Press the MENU button. In SYSTEM MENU, select
SYSTEM SETUP >> to enter the SYSTEM SETUP
menu, and then select oxyCRG SCREEN in the
FACE SELECT sub-menu.
View Bed The main screen displays the
information.
Press the MENU button. In SYSTEM MENU, select
SYSTEM SETUP >> to enter the SYSTEM SETUP
menu, and then select VIEWBED SCREEN in the
FACE SELECT sub-menu.
Waveform Scroll The waveforms are displayed
in the scrolling manner
Press the MENU button. In SYSTEM MENU, select
SELECTION >> to enter the SELECTION menu,
and then set SCAN TYPE to SCROLL.
Parameter Alarm Limit The parameter zone of the
main screen displays the alarm
limits of parameters.
Press the MENU button. In SYSTEM MENU, select
SELECTION >> to enter the SELECTION menu,
and then set ALM LIMIT to ON.
Drug Calculation and
Titration Table
The system provides the
function of calculating 15
drugs and displaying the
titration table as well as
outputting the contents of the
titration table by the recorder.
Press the MENU button. In SYSTEM MENU, select
DRUG CALC >> to enter the DRUG CALC menu.
Then the DRUG CALC information and
TITRATION information can be viewed.
Arrhythmia Analysis
and ST Analysis
The patient monitor has the
functions of the arrhythmia
analysis and ST analysis.
Select the ECG label and press the control knob to
enter the ECG SETUP menu, and then select ARR
ANALYSIS >> and ST ANALYSIS >> respectively
to enter the ARR ANALYSIS sub-menu and the ST
ANALYSIS sub-menu.
ECG Lead Type You can select either 3 leads
or 5 leads, depending on the
ECG cable used.
Select the ECG label and press the control knob. In
the ECG SETUP menu, set LEAD TYPE as needed.
ECG Multi-Leads
Waveform Display
The 6 displayed ECG
waveforms occupy the whole
waveform area or only half the
waveform area. full screen.
Select the ECG label and press the control knob. In
the ECG SETUP menu, select OTHER SETUP >>,
and then set ECG DISPLAY to MULTI-LEADS
DISPLAY or HALF-SCN MULTI-LEADS.
To Next Page
Loading...
Need help?
General
