14 Measurement, Comments and Body Mark
Operator’s Manual 14 - 7
14.3 Voice Comments
The system supports adding voice comment to the frozen images.
• To perform voice comments adding, the function should be enabled through the path: [Setup] >
[System] > [Application]. Check “Voice comment enabled”. The voice comment panel appears
on the right corner of the screen.
• It only supports the vocal input from the wired microphone.
14.3.1 Voice Comment Panel
After the system enters the voice comment status, the voice comment panel will be displayed on the
lower right corner of the screen.
14.3.2 Adding Voice Comments
• In voice comment recording status, you can perform measurements, comments adding, body
marks adding, print tasks and DICOM tasks.
• If you press <Freeze> during the recording course, the already recorded voice comment cannot
be saved.
1. Connect the microphone to the mic port of the front I/O panel. The microphone icon appears
highlighted.
2. Press <Freeze> after obtaining the image. Press <Cursor> and roll the trackball to move the
cursor onto the voice comment panel; tap to start recording and the icon becomes red.
3. After the voice recording ends, tap the icon to end recording.
4. Save the cine.
14.3.3 Voice Comment Review
Click to open a cine file with voice comment, and during the cine review mode, voice comments
are played as well.
1 Start/Stop Recording 2 Recording
3Duration
To Next Page
Loading...
Need help?
General
