Beep Tones Repair Information
1 - 22 0070-10-0556-02 Spectrum
®
/Spectrum OR
™
Service Manual
1.24 Beep Tones
The following tables describe the beep tones associated with the Spectrum
®
and
Spectrum OR
™
monitors:
POWER ON (SPECTRUM
®
AND SPECTRUM OR
™
)
Normal Operation 1 beep
Runtime Stack Failure 2 beeps
DRAM Memory Failure 3 beeps
PCMCIA Boot Checksum Failure 4 beeps
PCMCIA Image
Checksum Failure
5 beeps
Flash Checksum Failure 6 beeps
Flash Programming Error 7 beeps
DRAM Checksum Error 8 beeps
ALARMS (SPECTRUM
®
)
High Priority 3 beeps/2 beeps/3 beeps/2 beeps, repeated every 10 seconds
Medium Priority 3 beeps, repeated every 30 seconds
NORMAL OPERATION (SPECTRUM
®
)
CO
2
Occlusion 2 beeps, repeated every 4 seconds
NIBP Unable to Measure 1 beep
Low Battery 2 beeps, repeated every minute
ECG Noise 2 beeps, repeated every 13 seconds
ALARMS (SPECTRUM OR
™
)
High Priority 3 beeps/2 beeps/3 beeps/2 beeps, repeated every 10 seconds
Medium Priority 3 beeps, repeated every 10 seconds
NORMAL OPERATION (SPECTRUM OR
™
)
CO
2
Occlusion 2 beeps, repeated every 4 seconds
NIBP Unable to Measure 2 beeps with the second beep lower in pitch than the first
Low Battery 2 beeps, repeated every minute
ECG Noise 2 beeps, repeated every 13 seconds
NIBP End Tone 2 beeps with the second beep higher in pitch than the first
To Next Page
Loading...
