Mindray Spectrum - Transferring Monitor Default Settings

Installation Menu Repair Information
1 - 40 0070-10-0556-02 Spectrum
®
/Spectrum OR
™
Service Manual
1.26.2 Transferring Monitor Default Settings
When installing several monitors with identical display and alarm settings, a Transfer Card
(Spectrum
®
P/N 0996-00-0094-01 only, Spectrum OR
™
P/N 0996-00-0171-01 only)
can be used to copy the settings from monitor to monitor.
1. Insert the Transfer Card into the PCM2 slot on the right side of the source monitor.
2. Access the Functions menu, and select Copy monitor defaults to card from the
menu. A status message will report completion of the transfer.
3. Remove the card and insert it into the PCM2 slot of the receiving monitor.
4. Enter Installation Mode on the receiving monitor by pressing and holding the
DISCHARGE key (Spectrum
®
) or the TRENDS key (Spectrum OR
™
) while
powering ON the monitor.
5. Select Copy monitor defaults to card. A status message will report completion of
the transfer.
6. Select Save Current and power-cycle the receiving monitor to enter normal monitoring
mode.
Set up Serial Port 1 None, VISA with
admit, DIAP, Accutorr,
Gas Module, Patient
Net (menu choices are
present only if options
are installed)
None Select to set up a serial
output protocol port
Set up Serial Port 2 None, VISA with
admit, DIAP, Accutorr,
Gas Module, Patient
Net (menu choices are
present only if options
are installed)
None Select to set up a serial
output protocol port
Re-boot in demo mode Yes, No No Set to YES to start the
monitor in
demonstration mode on
next power-up. Normal
monitoring will resume
after cycling power in
demonstration mode.
Restore factory
defaults
Select to restore factory
defaults
System Information Select to set up users
screen
Change Password Select to change
password.
Options Select to add/view
options
MENU TITLE ON
SCREEN MENU CHOICES DEFAULT
ACTIONS/
COMMENTS