3. Device description | 3.2 - Overview of the device | 23
3.2 Overview of the device
– Accuracy 6,000d (ClassIII) for the weighing electronics
– High-speed conversion with response times from upto 10ms
– Weight display with status and mass unit on a TFT Color touch display
– Digital filter with adjustable characteristic line
– Electrically isolated interfaces
– 3 programmable pairs of limits
– Supply voltage connection U
DC
=24 V
– Connection via plug connector for load cells, inputs and outputs, serial in
terfaces
– Ethernet connection
– The device is snapped to a mounting rail.
The menu-guided adjustment and configuration of the device are carried out
on a notebook/PC via ethernet.
– Adjustment using weights according to the mV/V method or directly us
ing load cell data (SMART calibration)
– Analog output 0/4 to 20 mA, configurable for gross/net weight (only PR
5215/10 and ../11)
– Analog weight value via field bus
– 3 digital inputs, electrically isolated
– 3 digital outputs, electrically isolated
–
Overwrite protection:
via CAL switch (on the front of the device)
3.2.1 Communication protocols
For RS-485:
– Remote display protocol
– SMA protocol
– ModBus-RTU protocol
Field bus slave:
–
ProfiBus‑DP
– DeviceNet
–
CC‑Link
– ProfiNet I/O
– EtherNet/IP
– EtherCAT
To Next Page
Loading...
Need help?
General
