5. Getting started | 61
5 Getting started
5.1 Switching on the device
The device is started up via a notebook/PC using an Internet browser.
Note:
The following steps must be followed when connecting the device to
mains voltage for the first time:
– Assign password, see Chapter Assign password
– Set the date and time, see Chapter Current date & time.
– Set up the network (only necessary if the device is to be used or con
figured in the network), see Chapter Connect device to the network.
5.2 Switching off the device
The device is switched off by disconnecting the supply voltage (24 V) or by
loosening the plug connector.
5.3 Device warm-up time
A warm-up time of30 minutes for the device is required before adjustment/
calibration is started.
5.4 Power failure
In the event of a power failure, all entered configuration, adjustment and
calibration parameters are retained.
To Next Page
Loading...