4. Device installation | 4.3 - Hardware construction | 59
Note:
The EDS file is available to download online:
http://www.minebea-intec.com
4.3.12 EtherCAT interface
The EtherCAT fieldbus is a complete EtherCAT adapter (slave) for the network
connection with full duplex features of 100BASE-TX. These are fully utilized so
that effective data rates of almost 200 MBit/s can be achieved.
EtherCAT is an open technology that is standardized in IEC 61158 and IEC
61784 as well as in ISO 15745-4.
The interface can be configured by software.
Technical data
Description Data
External connection 2×
RJ‑45
plug connector (female)
Transfer rate approx. 200MBit/s
Full duplex
Protocol EtherCAT
Cyclic transmission of I/O data
Acyclic transmission of data such as parameters, di
agnostics, device identification
Connection mode Network
Configuration EDS file "min_5215_EtherCAT-2Port.xml"
To Next Page
Loading...