6. Operating | 6.9 - Serial interface | 90
6.9 Serial interface
: [Interfaces]
1. Click [Serial interface].
A selection window appears.
2.
Select the individual parameters and change them if necessary.
[Protocol]
Selection: None, Remote display, SMA, Modbus-RTU
[Baudrate]
Selection: 300, 600, 1200, 4800, 9600, 19200 Baud
Other parameters are protocol specific.
3. Save the settings.
6.10 Digital inputs & outputs
: [Digital inputs & outputs]
1. Select the individual parameters and change them if necessary.
[Input 1…3]
Selection: None, Set zero, Set tare, Reset tare
[Output 1…3]
Selection: None, ADC error, Limit 1, Limit 2, Limitr 3, Tare active
2. Save the settings.
To Next Page
Loading...
Need help?
General
