Minebea Intec MiNexx-link-E PR 5215/01 - Function Numbers

9. Fieldbus interface | 9.2 - Scale protocol | 116
Action of the master Slave reaction
Set the ResetError bit (for func
tion number121, see Chap
terFunction number 112–121:
transition-controlled action bits
(write)).
The ResetError bit is reset.
The CmdError bit is reset.
9.2.5 Function numbers
Function numbers are written to MOSI by the master (SPS) and reflected in
MISO by the PR 5215.
– Function number 0: I/O status bits (read), see ChapterFunction number
0: I/O status bits (read)
– Function number 1: scale status (read), see ChapterFunction number 1:
scale status (read)
– Function number 4: adjustment information, error byte (read), see Chap
terFunction number 4: adjustment information, error byte (read)
– Function number 5: device type and software version (read), see Chapter
Function number 5: device type and software version (read)
– Function number 6: serial number of the weighing point (read), see Chap
terFunction number 6: serial number of the weighing point (read)
– Function numbers 8 to 15: weight data (read), see ChapterFunction num
ber 8–11, 14: weight data (read)
– Function numbers 22 to 27: Limit value (read/write), see ChapterFunction
number 24–29: Limit value (Read/Write)
– Function numbers 30, 31: values of the current weighing point (read), see
ChapterFunction number 30, 31: Fixed values (Read/Write)
– Function numbers 80 to 93: state-controlled action bits (write), see Chap
terFunction number 80–89: state-controlled action bits (write)
– Function numbers 112 to 119, 121 to 125: transition-controlled action bits
(write), see ChapterFunction number 112–121: transition-controlled ac
tion bits (write)