MIR 250 - 15.2 Packing the robot for transportation; 15.3 Battery

15. Packing for transportation
MiR250 User Guide (en) 11/2020 - v.1.3 ©Copyright 2020: Mobile Industrial Robots A/S. 190
• The bottom of the box (the pallet)
• The lid of the box (the ramp)
• The walls of the box
• Protective foam blocks: Side blocks and the top layer
• Protective corner braces. The braces prevent the robot from being damaged by the
transport straps
15.2 Packing the robot for transportation
Before packing the robot for transportation:
• Shut down the robot—see Shutting down the robot on page60.
• Disconnect the battery—see Disconnecting the battery on page63.
To pack the robot, repeat the steps in Unpacking MiR250 on page45 in the reverse order.
NOTICE
Pack and transport the robot in an upright position. Packing and transporting
the robot in any other position voids the warranty.
15.3 Battery
The lithium-ion battery is subject to transport regulations. Make sure that you follow the
safety precautions in this section and the instructions in Packing for transportation on the
previous page. Different regulations apply depending on the mode of transportation: land,
sea, or air.
Contact your distributor for more information.
CAUTION
Lithium-ion batteries are subject to special transportation regulations
according to United Nations Regulation of Dangerous Goods, UN 3171. Special
transport documentation is required to comply with these regulations. This
may influence both transport time and costs.