Installation
Settings
The IP address can either be taken from a DHCP server in the IP network or configured statically. If a DNS
server is used, the communication server can also be addressed via its host name.
Table 62: Default values, IP address
Parameter Parameter value
Name Name of the LAN connection on the mainboard of
the SMB Controller. Click eth0 ... eth3 to enter the
edit view of the network interface. Note that eth0
interface is primarily used for the communication
server application and the other interfaces are
used for the multi-gateway functionality.
Status Connection status (Up or Down) of the Ethernet
port
Carries Physical connection status of a network cable
(Plugged or Unplugged)
DHCP
Click DHCP to address the SMB Controller
through DHCP. If DHCP is disabled, the network
parameters must be entered manually. For static
addressing of the SMB Controller (recommended),
enter a fixed IP address, subnet mask, and the IP
address of the default gateway in the respective
fields
IP address IP address of the SMB Controller. For example:
192.168.104.13
Subnet mask Range of the subnet. For example: 255.255.255.0
Gateway IP address of the default gateway. For
example: 192.168.104.1
MTU MTU stands for Maximum Transaction Unit. It
is defined as the maximum size of each packet
transmitted in a single network transaction.
Release 7.1
System Manual for Mitel SMB Controller 152
To Next Page
Loading...
Need help?
General
