Configuration
5.8.3.2 First start
A first start has the effect of resetting the MiVoice Office 400 communication server from scratch. The
system-specific data such as the system ID, system type, sales channel, licence file, and software
generation are preserved.
Note:
• A first start deletes all the configuration data already stored and replaces it with the default values
of the sales channel. Therefore, back up your configuration data before a first start.
• The first start is triggered immediately. All the active call and data connections are interrupted.
First start via WebAdmin
A first start via WebAdmin is triggered in the maintenance settings with the First start button in the System
reset view.
First start via front panel
A first start via front panel is done using the pilot key (see Carry out a first start of MiVoice Office 400).
First start and reset sales channel via WebAdmin
With the First start and reset sales channel button in the maintenance settings of the WebAdmin System
reset view, you have the possibility not only to execute a first start but also to delete the sales channel.
During the next start, you will be prompted for the sales channel and licence file. Note that the licence file is
dependent on the sales channel. This means you can no longer use the existing licence file, if you choose
another sales channel.
Note:
This function is only accessible for Administrators in Expert mode.
5.8.3.3 Factory Reset
A factory reset of the SMB Controller is triggered in the SMB Controller Manager maintenance settings with
the Factory reset button in the System reset view.
Release 7.1
System Manual for Mitel SMB Controller 190
To Next Page
Loading...
Need help?
General
