Operation and Maintenance
Event message Trigger condition
Details
63
Severity
ESME reachable The LAN connection between
the SMSC and the ESME is now
available
IP address, date,
time
critical (positive,
with match)
ESME unreachable The LAN connection between the
SMSC and the ESME is interrupted
IP address, date,
time
critical (negative,
with match)
Ethernet activated
again
The overload on the Ethernet
interface no longer exists. The
interface has been reactivated.
Date, time Normal (positive,
with match)
Ethernet deactivated
due to high load
The system has detected an
overload on the Ethernet interface.
The interface is temporarily
deactivated.
Date, time Normal (negative,
with match)
External auxiliary
power supply failed
(Mitel 470 only)
The external auxiliary power supply
to the communication server has
failed. If the auxiliary power supply
unit has been used for redundant
operation, there are no short-
term limitations. If the auxiliary
power supply unit has been used
to increase the power supply, the
internal power supply unit overflow
must be calculated.
Date, time Serious (negative,
with match)
External auxiliary
power supply in
service (Mitel 470 only)
The external auxiliary power supply
to the communication server is
working.
Date, time Serious (positive,
with match)
External event
message destination
not reachable
External signal destination not
automatically reachable
Cause (0: Busy /1:
Not available /2:
(not used), 2:
Barred /3: not
defined), date,
time
Serious (negative,
with match)
External event
message destination
reachable
External signal destination is now
reachable
Date, time Serious (positive,
with match)
63
The node is also always indicated in an AIN.
Release 7.1
229 System Manual for Mitel SMB Controller
To Next Page
Loading...
Need help?
General
