Before the program is able to function as intended it is necessary to input data into the physical
MELSEC addresses occupied by the array variables. There are two ways in which this may be
achieved:
쎲 Use the
Device Edit
feature from the
Debug
menu as previously described, using
Insert
Devices
in the range D100 to D109, and enter any 10 random integer values between
-32768 to +32767 and write them to the PLC.
쎲 Open the
EntryDataMonitor
feature from the
Online
menu.
–
Right Click on the
Address
or
Name
column headers and select
Insert Objects
from
the menu list as shown:
Arrays Array Example: Single Dimension Array
Training Manual GX IEC Developer 11 - 5
To Next Page
Loading...
