Introduction
This manual describes the items required for installing, connecting and setting up the Mitsubishi Electric CNC.
Read this manual thoroughly and understand the product's functions and performance before use.
Supported models of this manual are as follows:
Abbreviations for model names used in this manual are as follows:
To safely use this CNC unit, thoroughly study the "Precautions for Safety" before use.
Be sure to keep this manual always at hand.
Also refer to the manuals on "Manual List" as necessary.
Notes on reading this manual
(1) This manual is written on the assumption that all optional functions are added, but the actually delivered device may not
have all functions.
The unit names, cable names and various specifications are subject to change without notice. Please confirm these
before placing an order.
(2) This manual explains general parameters which are operated on the CNC side.
For information about each machine tool, refer to manuals issued from the machine tool builder.
If the descriptions relating to "restrictions" and "allowable conditions" conflict between this manual and the machine tool
builder's instruction manual, the later has priority over the former.
(3) This manual is intended to contain as much descriptions as possible even about special operations.
The operations to which no reference is made in this manual should be considered "impossible".
(4) This manual is for the machine tool builders who set up the CNC system.
(5) Do not connect to the pin described as "NC" on the pin assignment table of the connector.
(6) The characteristic values and numerical values without tolerances mentioned in this manual are representative values.
Supported models Abbreviations in this manual
M800VS Series M850VS, M830VS
M80V Series M80V TypeA, M80V TypeB
Abbreviations Supported models
M800V, M800V Series M800VS Series
M80V, M80V Series M80V Series
M800V/M80V, M800V/M80V Series M800VS Series/M80V Series
M8V, M8V Series M800VS Series/M80V Series
To Next Page
Loading...
