1-19 1-19
1. Usage
This explains precautions you need to know before using this software.
1.1. How to Use this Document
The manual is in the DVD-ROM as the Adobe PDF file.
D:/Doc/RT3Manual.pdf (Example for the DVD drive is “D :”.)
For reading the manual in the DVD-ROM, Adobe Reader is required.
If Adobe Reader isn’t installed, please download from the following Adobe Systems Incorporated URL (As of
November, 2019)
URL: http://www.adobe.com/
1.2. Checking the Product
1.2.1. Checking the package
Please check if all items shown below are included in the package.
- DVD-ROM "RT ToolBox3"
- Setup Guide
- END-USER SOFTWARE LICENSE AGREEMENT
- License Certification
(Please make sure Product ID is printed on it.)
* Please contact the branch office or the agency if there is some shortage in the package.
1.2.2. Checking the DVD-ROM contents
The DVD-ROM has the following configuration.
1.2.3. About the "MelfaRXM.ocx" communications middleware
MelfaRXM.ocx is the ActiveX control that communicates with the robot-controller. You can create the Windows
Application of "MELFA ROBOT" by using this control.
You can use "MelfaRXM.ocx" in the standard version of this software only.
For information on how to set up "MelfaRXM.ocx", refer to "26 MelfaRXM.ocx Communications Middleware
Setup".
If using only the function of “RT ToolBox3”, you don't need to install this software.
The files for installation of this software
The folder for setup of the communication middleware "MelfaRXM.ocx"
The sample data (Layout, Hand model)
To Next Page
Loading...
Need help?
General
