1-38 1-38
1.5.5. CRnQ_R Communication USB driver for GOT transparent function / GOT
communication installation
Connecting the CR800-R/CR800-Q/CR750-Q/CRnQ-700 series robot controller by USB via the GOT transparent
mode (Bus, Direct coupled or Ethernet) and connecting the CR800-D/CR750-D/CRnD-700 series robot controller by
USB via GOT communication requires installation of the USB driver for the GOT transparent function. Install by the
following procedure.
1.5.5.1. When using Windows XP
The following indicates the procedure for installing the USB driver when using Windows (Professional)
1) The screen shown on the left appears
when you connect the personal
computer and GOT with a USB cable.
Choose "Yes, now and every time I
connect a device" and click the [Next]
button.
2) The screen on the left appears. Select
"Install the software automatically
(Recommended)", then click the [Next]
button.
3) The screen on the left appears. Click
the [Continue Anyway] button to
continue the installation of the USB
driver.
(No problems will occur after
installation of the USB driver.)
To Next Page
Loading...
Need help?
General
