Mitutoyo CONTRACER CV-2100 - Installing the Measuring Main Unit

2. Installation
No. 99MBB793A
2-5
2.3 Installing the Measuring Main Unit
This section describes how to install the measuring main unit.
1. Insert the measuring main unit into the mounting hole of the stand.
2. Use the supplied hex wrench (nominal 3) to secure it firmly.
Important
Do not hold the quick up/down handle in the state that the measuring main unit is not
installed. Failure to observe this may generate a strong upward force and make the
situation dangerous because it is not balanced.
NOTE
The measuring main unit shall be used after mounting it on the stand or a jig. Failure to
observe this may cause an inability to satisfy the product specifications.
2
1