Mitutoyo CONTRACER CV-2100 - Stylus Positioning

3. Preparation for measurement
No. 99MBB793A
3-11
3.7.3 Stylus positioning
Refer to "3.7.1 Moving in the X-axis direction" for positioning in the X-axis direction. For
positioning in the Z-axis direction, height adjustment is performed within the Z1-axis
measuring range with use of the quick up/down handle or up/down fine feed knob.
NOTE
CV-2100N4 is not equipped with the height adjustment mechanism. Height adjustment
shall be performed with the mounting jig or workpiece setting jig.
TIP
When measurement is repeatedly performed with the measuring main unit at the same
position, applying a limit to the downward movement of the measuring main unit by using
the positioning stopper allows positioning to be simply performed.
Quick up/down handle
Up/down fine feed knob
Up/down fine feed knob
Positioning stopper