Mitutoyo CONTRACER CV-2100 - Removing the Measuring Main Unit

2. Installation
No. 99MBB793A
2-7
2.5 Removing the Measuring Main Unit
This section describes how to remove the measuring main unit.
1. Raise the measuring main unit to the highest position.
2. Use the supplied hex wrench (nominal 3) to loosen it.
3. Remove the measuring main unit from the stand.
Important
Do not hold the quick up/down handle in the state that the measuring main unit is not
installed. Failure to observe this may generate a strong upward force and make the
situation dangerous because it is not balanced.
NOTE
The measuring main unit shall be used after mounting it on the stand or a jig. Failure to
observe this may cause an inability to satisfy the product specifications.
2
3
1