Mitutoyo CONTRACER CV-2100 - Setting the Measurement Conditions; Starting a Measurement

No. 99MBB793A
3-24
3.10.2 Setting the measurement conditions
The measurement condition setting is performed with the analysis software,
"FORMTRACEPAK". Refer to the user’s manual of analysis software for further
information.
3.10.3 Starting a measurement
(1) Measurement can be started with the start switch on the measuring main unit.
(2) Measurement can also be started with the analysis software.
Refer to the user’s manual of the analysis software for further information.
[Set Meas
Condition...]
Start switch
[Measure] button