Mitutoyo CONTRACER CV-2100 - Optional Accessories

No. 99MBB793A
6-6
6.4 Optional Accessories
Optional Accessories
Order No.
Item name
Remarks
218-042
Column stand
12AAG175
Calibration stage
218-171
Cross-moving table (mm)
218-172
Cross-moving table (inch)
178-195
Leveling table
218-002
Rugged table
178-019
Precision vise
218-173
* Two-slide jaw rotary vise
172-196
* Rotary table
176-107
* Holder with clamp
172-602
* Rotary vise
172-604
* Swivel center support
178-185
Cross-travel table (Digimatic, mm)
178-186
Cross-travel table (Digimatic, inch)
178-183
Cross-travel table (venier, mm)
178-184
Cross-travel table (venier, inch)
178-182
3 axes adjusting table
172-603
* V-block with clamp
172-378
* V-block with clamp
998291
V-block with clamp
172-600
* Center support
172-601
* Center support riser set
178-023
Vibration isolator
Only a pump-fed standard base type is
supported.
178-024
Stand for vibration isolator
178-025
Vibration isolator
Only an air-fed standard base type is supported.
166-215
Workbench
218-007
Workbench
218-008
Workbench
218-010
Workbench
178-188
Vibration isolator
12AAK120
Monitor arm
178-181
Side table
998862
Pin gage unit (mm)
998861
Pin gage unit (inch)
211-016
Reference hemisphere
12AAJ088
Foot switch
* An optional accessory to be used with a cross-moving table (218-171, 218-041) or with a sturdy table
(218-002).