13. Click the [Next] button.
Click the [Next] button, since the straightness correction measurement will not be
performed.
14. Click the [Next] button.
Click the [Next] button, since the symmetry correction measurement will not be
performed.
• For the symmetry correction, the reference hemisphere (P/N. 211-016), one of
optional accessories, is required.
15. Click the [Finish] button.
Click the [Finish] button since the stylus radius will not be measured.
• For the stylus radius measurement, the pin gage unit (P/N. 998862/ P/N.998861),
one of optional accessories, is required.
To Next Page
Loading...
