19
No. 99MAH056A
3 Basic Usage
(Short press) / (Long press)
3.6
Switching Unit System
The unit display can be switched between mm and in.
1
F1
1 Press the [F1] key.
» Each time the key is pressed, the unit display switches.
Tips
• This function is available only when the following measurement mode and switch
function selection are set.
Measurement mode Switch function selection
Standard 1 Default
Standard 1 [F1] key = [unit]
Standard 2 -
When peak detection is selected in measurement mode selection, this function
cannot be used. Change units with unit system selection in the parameter setting
mode.
For details about measurement mode selection, switch function selection and unit
system selection, see
"5.1 Selecting Parameter Items" on page 35.
• When the unit is switched, the following will be converted accordingly: display value,
preset values, tolerance value, resolution, and analog bar graduation.
• Ifitcausesadisplayvalueoverowerror(Err30),settheproperresolution.For
details, see
"8 Error Displays and Countermeasures" on page 83.
• Additionally,ifthereisanoveroworconversionerrorafterswitchingunits,
checking the values of each setting is recommended.
To Next Page
Loading...
Need help?
General
