Mitutoyo ID-C Series - Adding;Removing the Coil Spring

67
No. 99MAH056A
5 Setting Parameters
(Short press) / (Long press)
1 Press the [F2] key.
» Calibration schedule warning can be set.
2 Select ON/OFF for the calibration schedule warning.
1 Press the [F1] key or [F3] key.
» Each time the key is pressed, the calibration schedule warning turns ON/OFF
alternately.
2 Press the [F2] key.
If [on] is selected:
» The current date becomes settable and [todAy] blinks.
If [oFF] is selected:
» Selectionisconrmed;shiftstothenextparameteritemof"Otherfunction
changes".
(Go to "5.11.3 Selecting Digimatic Output" on page 71.)