MKN FKECOD615T - Causes of Errors and Remedies (Part 2)

Troubleshooting
89Operating instructions
Fault
no.
Error message
displayed
Description Measure to be taken
715
717
• External core
temperature
sensor is defect-
ive
The external core
temperature sensor in
the cooking zone is
deactivated.
• Use the internal
core temperature
sensor.
• Contact Customer
service.
710 • Vapour sensor
defective
Vapour elimination is
now only controlled by
the software. This
results in higher water
consumption.
• Contact Customer
service
• Water pressure
too low
As permanent error
message
• Open the water
valve
• If the water valve is
not closed, contact
Customer service
• Water pressure
too low
As sporadic error
message
• Activate fewer sim-
ultaneous water
consumers in the
kitchen.
• Contact Customer
service
• No water in the
waste trap
The waste trap is not
filled with sufficient
water.
• Open the water
valve
• 2 l Pour water into
the cooking zone
• If the error message
persists, contact
Customer service
• Unit restarted
after a power fail-
ure
If there was no power
failure in the kitchen, it
could be an operating
error. An example of
this would be
unintentional
switching on and off
during a running
cooking program.
• Power failure < 1
minute
• Confirm the power
failure message
• Continue with the
cooking program
• No cleaning neces-
sary
• Power failure > 1
minute
• Cooking program
cancelled
• Perform cleaning
• WaveClean can-
celled
• Please observe the explanations and notes in
the chapter on "Automatic cleaning (Wave-
Clean)"
10013865-0ABBE-B