Activate Recording3.5.3
Follow these steps to activate the recording to a MicroSD card that has already been
MxFFS-formatted (
):
Make sure that there is a MicroSD card in the card slot of the MOBOTIX camera.
1.
Make sure that the MicroSD card is formatted in MxFFS format.2.
Activate the 3. option.
Click
4. Set, then Close to store the configuration.
Reboot the camera (
5. Admin Menu > Reboot Camera).
Once the camera has rebooted, make sure that the camera displays the FR REC symbols
in its live image. If this is the case, the camera uses the MicroSD card as recording target.
If not, you must activate the recording (see below).
If the symbols FR REC are not visible in the live image after rebooting, you need to activate
the recording using one of the following methods:
• Automatic activation by clicking the Arm & Record soft key.
Confirm this in the Easy Dialog by clicking
yes.
•
Manual activation via the Quick Control Recording > Recording
on or in Setup Menu > Recording.
MxEasy: It is possible to activate the recording based on the time or date using the
•
Alarm Planner of MxEasy (see MxEasy User Manual).
If security is an issue, you can opt to store only encrypted video data on the MicroSD
card. If you would like to use encryption, make sure that you activate this option when
formatting the card. Note that you also need to enter an authentication password. Switching
from encrypted to unencrypted storage (and back) is not possible without reformatting
the SD card.
Activating the storage
device: Admin Menu >
Storage on External File
Server / Flash Device
This feature will be
available in future
software versions
To Next Page
