76/126
www.mobotix.com • sales@mobotix.com
OPERATING THE CAMERA3
Manual And Automatic Operation3.1 – Overview
MOBOTIX cameras do not require any extra software. Thus, you can set up and operate
the MOBOTIX camera using a JavaScript-enabled browser on all common operating
systems (such as Windows, Linux, Macintosh, etc.). As an alternative, you can also use
the MOBOTIX applications MxControlCenter and MxEasy. Follow these steps in order to
set up the camera:
1. Power is supplied directly via the Ethernet
cable (see Chapter 2)
2.
• (see Section 3.2.1 f)
• (see Sections 3.2.3 and 3.2.4)
or via DHCP (see Section 3.2.6)
3.
using the browser-based user interface, with MxControlCenter
or with MxEasy.
Every MOBOTIX camera comes preconfigured with a fixed IP address in the 10.x.x.x range
(for example, 10.8.0.99). Local computer networks usually have IP addresses in the
172 or 192 ranges. In order to access a MOBOTIX camera via the network, the camera
needs to get an IP address in the same address range. You can
: ,
using MxCC and
or by DHCP.
Camera software
in the browser
Download the
free-of-charge MxEasy
and MxControlCenter
software at
www.mobotix.com
To Next Page
Loading...
