Additional Notes3.7
3.7.1
Accessing the Administration menu of the camera (Admin Menu soft key) is only possible
after entering a user name and password.
Factory default user name is
• admin.
Factory default password is
• meinsm.
The Quick Installation assistant automatically appears when the Administration menu is
accessed for the first time. It provides an easy method to adjust the basic camera settings
to the current application scenario. For security reasons, we highly recommend changing
the default administrator password after the camera has been properly configured.
Enter the user name and password exactly as shown above. Note that all entries are
case-sensitive.
Caution
Make sure that you store information on user names and passwords in a secure place.
If you lose the administrator password and cannot access the administration menu,
the password can only be reset at the factory. This service is subject to a fee!
3.7.2
Deactivating a camera's microphone may be necessary in order to protect the privacy of
persons at a workplace or for other reasons. You can permanently and irreversibly deactivate
the microphone in the dialog.
Caution
This deactivation is permanent and cannot be reversed, even at the factory.
Deactivating the microphone will also deactivate all features that use the camera’s
microphone.
3.7.3
If the camera's IP address is not known, you can start the camera with its factory IP
address. Section 3.2.6
Starting the Camera with the Factory IP Address
describes this
procedure in more detail.
The microphone can be
irreversibly deactivated!
To Next Page
